Welcome to the website of Qingzhou Ludong Machinery Co., Ltd. We will serve you wholeheartedly!

Your Position:Home » Product Show » JZM series rubber wheel drive mixer

JZC series gear drive drum mixer
JZM series rubber wheel drive mixer
JS series double-shaft forced mixer
PLD series concrete batching machine
HZS simple concrete mixing plant
HZS standard concrete mixing tower
WDB Stabilized Soil Mixing Station
Integral cement warehouse
Chip cement warehouse
other products

JZM500 Crawler Feed Mixer

Date: 2018-04-14 10:55:57 Click:

 

Uses and Features :

This machine belongs to bipyramid reversal discharging mobile concrete mixer can mix plasticity and low fluidity concrete , stir DrumDischarge Capacity is 0.35,0.45,0.5 cubic meters. 100 seconds each agitation cycle , 12,18,25 cubic meters per hour production rate for general construction sites, roads and bridges projects and medium-sized concrete plant .

This machine has high productivity, good mixing quality , simple structure , high degree of automation , easy to manipulate and so on.

Machine installation :

1 , after site preparation in place , dig a 1.3 m long , 1.4 meters wide , 1 meter deep pit . Slightly higher than the horizon pit to prevent water flowing into the pit . Pit with a brick masonry and mortar gray surface to prevent leakage.

2 , move the machine to make a pit alignment rack , remove traction frame , the track will take a long rack of turning down into the pit , tighten the screw connection , take a long orbital position to observe whether it is appropriate , when necessary, adjust the position of the machine.

3 , put the four legs , lower legs should pad the block , then turn the legs of the screw, the rack from the top , so that the tire off the ground , and adjust the rack to a horizontal position , in order to enhance the stability of the machine and reduce the Drum of axial movement . When used in a fixed operating area. The machine can be used sleepers erected ( remove tires ) , then adjust the machine to level. ( Note : Drum axis shall not exceed the discharge end of the feed end )

4, with the wood will take a long track pad is , when the track to prevent the work force and deformation .

Details:

Model JZM500
type Friction wheel drive to climb bucket feeding
Discharge Capacity(L) 500
Feed Capacity(L) 800
Maximum Productivity(m3/h) 18-20
DrumSpeed(r/min) 13
Maximum aggregate size(mm) 60
Stirring motor(kw) 5.5*2
Winch motor(kw) 5.5
Pump motor(kw) 0.75
Maximum towing speed(km/h) 20
Total mass(kg) 2217
Dimensions(mm) 4310×2140×4240