JZC350B climbing bucket feeding mixer

Uses and Features :

This machine belongs to bipyramid reversal discharging mobile concrete mixer can mix plasticity and low fluidity concrete . Stir DrumDischarge Capacity 0.35,0.45,0.5 cubic meters respectively . 100 seconds each agitation cycle , the production rate of 12 cubic meters per hour . For general construction sites, roads and bridges projects and small and medium sized concrete plant .

This machine has high productivity, good mixing quality , simple structure , high degree of automation , easy to manipulate and so on.

Machine installation :

1 , after site preparation in place , dig a 1.3 m long , 1.4 meters wide , 1 meter deep pit . Slightly higher than the horizon pit to prevent water flowing into the pit . Pit with a brick masonry and mortar gray surface to prevent leakage.

2 , move the machine to make a pit alignment rack , remove traction frame , the track will take a long rack of turning down into the pit , tighten the screw connection , take a long orbital position to observe whether it is appropriate , when necessary, adjust the position of the machine.

3 , put the four legs , lower legs should pad the block , then turn the legs of the screw, the rack from the top , so that the tire off the ground , and adjust the rack to a horizontal position , in order to enhance the stability of the machine and reduce the Drum of axial movement . When used in a fixed operating area. The machine can be used sleepers erected ( remove tires ) , then adjust the machine to level. ( Note : Drum axis shall not exceed the discharge end of the feed end )

4, with the wood will take a long track pad is , when the track to prevent the work force and deformation .

5, JZC350B, 450B, 500B concrete mixer degree of automation is relatively high, more electrical components to prevent electrical components must take anti-canopy moisture and prolong the service life of the machine , the machine after installation .

Details: